** Japanese Industrial Standard (JIS) Screwdrivers **

I recently bought a set of crosspoints (#1,2 and 3). No need for a set containing slotted drivers.

JIS crosspoint.jpg
 
I know you use them, my Vessel's are holding up pretty well. Of course I learned to go for an impact driver instead of stripping things on the really tight screws but I still give mine pretty decent workouts

Please let us know how the tips hold up
 
87kawzl said:
I know you use them, my Vessel's are holding up pretty well. Of course I learned to go for an impact driver instead of stripping things on the really tight screws but I still give mine pretty decent workouts

Please let us know how the tips hold up
Click to expand...
So far, I've only used the #2 to drain the ZL600 carburetors and it got the job done but I found it shorter than I like to reach the far left float bowl. I just ordered a 300mm long one of the same brand. Pretty expensive at $18 on Amazon and it'll take a while to arrive being shipped straight from Japan where they're made :thumbsup:.

They won't see much action because I'll only be using these at home while my Snap-On drivers get used at the shop. I never let my cross head screwdrivers slip so unless they break or chip, I expect no problems.
 
I don't like the ridges on the point. I think Vessel even says they're not recommended for restoration work indicating they could ruin the surface finsh inside screw head and rust. I also like the handle shape on the SunFlag.
 
You must log in or register to reply here.
Back
Top