Carb airscrew tool

You gave me an idea I may try.
 
Harbor freight sells a smaller version of this that I have. It's a simple knurled bit holder. I seen that FCR tool while at Pinwall cycles and it looks too long to fit in the #2 carb
 
That's what I like to do Lowlife - make people think!
I know you had made a tool from a small screw driver that you customised!

Mark - I had expected that some of you guys would have seen this gadget or similar. I have not seen them over here in the UK - so could not say about the size etc. But will keep looking for things that could make things easier for us all!
 
I know this is old, anyone use one? I remember a tool like this at Boulevard Cycle, the guys used one there. I wish I knew someone that had one I could borrow, $27.95 + shipping... I'll burn my hands a bit longer.
 
You must log in or register to reply here.
Back
Top