One more attempt to get this running correctly

It ran well with COP mod, i did that a long time ago. I am going to strip the tank off and prod around with the meters and test tank. Maybe I can find a wonky wire from the fuse box plugs. I have a spare junction box somewhere but it hasn't shown itself, probably in a random box from when I moved. Right now a Z1000rs or a transalp looks good.
 
Well prfixer, I will be switching out the COP setup for the original coils and wires and see how that goes. AI said when the coils are wired in series (to get the required 2.8-3ohm resistance) it drops the voltage in half to each plug and that makes alot of sense. Ive had the bike so long and it's been out of commission for so long...
 
20260528_174214.jpg
Stick coils swapped out. Started and ran till the bowls were empty. After supper I will put the tank back on and giver a test run if she stays running long enough to turn on the fan. If it dies again I need some new clear hose because my old fishtank tubing is hard and I will do float level test while it runs to see if there is an obstruction in the fuel inlet rail.
 
Nope still ran like crap, then died. Alot more bounce of the tach with the original coils. Running float level testing next.
 
When was the last valve setting done?
 
You must log in or register to reply here.
Back
Top